PetSafe Deluxe In-Ground UltraLight Receiver Collar

  • Price:

    $74.55 FREE 1-2 Day Shipping on this item

In stock
cw-icon-heart Created with Sketch. Add to Favorites

Double the dogs means double the worry, unless you know everyone is playing safe and sound, right where they should be. The PetSafe Deluxe In-Ground UltraLight Receiver Collar lets you add an extra pup to the mix and keep her safe by providing 4 levels of adjustable static correction whenever she wanders where she shouldn't. The UltraLight Receiver Collar is compatible with all PetSafe In-Ground fences.

Key Benefits
  • Lightweight color weighs only 2.5 ounces and is for dogs 8 pounds and up.
  • 4 levels of static correction to match the sensitivity of your pet plus tone-only mode for training.
  • Uses PetSafe RFA-67 battery (included).
  • Compatible with PetSafe in-ground fences except UltraSmart® Rechargeable In-Ground Fence™ (PIG00-13619) and YardMax® Rechargeable In-Ground Fence™ (PIG00-11115).
  • Includes: adjustable nylon collar, battery, short contact points and operating guide.

Avoid leaving the collar on for more than 12 hours a day. Please refer to packaged instructions for additional details.

Click here for batteries.

Also works with the Indoor Radio Fence.

See all items by PetSafe

  • Item Number


Receiver Collar is not beeping or correcting.

  • Check battery to make sure it is installed properly.
  • Check that both lights are lit on the Fence Transmitter. If not, perform the “System Test” (page 27).

The Receiver Collar is beeping, but the pet is not responding to the Static Correction.

  • Test the Receiver Collar with the Test Light walking toward the Boundary Wire.
  • If the Test Light flashes, check the fit of the Receiver Collar.
  • Trim your pet’s fur where the Contact Points touch the neck and/or switch to the longer Contact Points.
  • Increase the Static Correction Level.
  • Repeat training steps to reinforce training.

The Receiver Collar has to be held on top of the Boundary Wire to activate.

  • Replace battery.
  • Adjust Boundary Width Control knob clockwise to increase the distance from the Boundary Wire that the Receiver Collar activates. Verify the Boundary Control Switch is placed at the proper setting according to the amount of Boundary Wire used. (See Step 6)
  • If using a Double Loop, make sure Boundary Wires are separated at least 5 feet.
  • If the Receiver Collar still has to be held on top of the Boundary Wire, perform the “System Test” (page 27).

The Receiver Collar activates inside the house.

  • Turn the Boundary Width Control knob counterclockwise to decrease the distance from the Boundary Wire that the Receiver Collar activates.
  • Make sure the Boundary Wire is not running within 15 feet of the house. The signal can transmit through the walls of your house.
  • Make sure Boundary Wires are twisted from Boundary to the Fence Transmitter.

The Receiver LED Indicator Light is flashing every 4 to 5 seconds and I have just installed a new battery.

  • To reset the low battery indicator, remove the battery from the Receiver Collar. Discharge all power by holding the correction level button down until the LED is no longer illuminated. Reinstall battery.

I have an inconsistent signal.

  • Make sure Fence Transmitter is at least 3 feet from large metal objects or appliances.
  • Make sure all Boundary Wire turns are gradual with a minimum 3 foot radius.
  • Make sure the Boundary Wire is not running parallel to and within 10 feet of electrical wires, neighboring containment systems, telephone wires, television or antenna cables, or satellite dishes.
  • If a neighboring containment system may be causing an inconsistent signal, move the Boundary Wire farther away from the neighboring containment system.

The Power and Loop Indicator Lights are off.

  • Check that the Power Adapter is plugged into the Fence Transmitter.
  • Check that the Power Adapter is plugged in properly.
  • If the system is plugged into a GFCI or RCD outlet, check to see if the circuit has been tripped. Reset the GFCI or RCD circuit if required.
  • Verify that the outlet is working properly by plugging in a known working item such as a radio.
  • Try plugging into another 120-volt outlet.
  • If the lights still do not come on, the Fence Transmitter and/or Power Adapter needs to be replaced. Contact the Customer Care Center.
  • If a Surge Protector is installed, unplug the Surge Protector and plug the power adapter directly into the outlet. If the Transmitter operates without the Surge Protector, contact the Customer Care Center for a replacement Surge Protector.

The Power Light is on, the Loop Indicator Light is off, and the Fence Transmitter loop alarm is sounding.

  • Check Boundary Wire connections at the Fence Transmitter for proper connection.
  • Check for broken or damaged Boundary Wires at outside entry to the house.
  • Perform the “System Test” (page 27) to determine if the Fence Transmitter or Surge Protector needs to be replaced.
  • If the Fence Transmitter is functioning properly, you have a break in your Boundary Wire. See the “Wire Break Location Test” (page 28) section in this guide.

The proper fit and placement of your receiver collar is important for effective training. The contact points must have direct contact with your pets skin on the underside of their neck.

  1. Make sure the receiver collar is turned off.

  2. Start with your pet standing comfortably.

  3. Center the contact points underneath your pets neck, touching the skin. If your pet has a long or thick coat, consider using the long contact points to reach through the fur. These can be purchased online or from our Customer Care Center. Note: It is sometimes necessary to trim the hair around the contact points to make sure that contact is consistent.

  4. Check the tightness of the receiver collar by inserting one finger between the end of a contact point and your pets neck. The fit should be snug but not constricting.

  5. Allow your pet to wear the collar for several minutes then recheck the fit. Check the fit again as your pet becomes more comfortable with the receiver collar.
  6. If you'd like to to trim the collar strap, mark the desired length of the receiver collar with a pen. Allow for growth if your pet is young or grows a thick winter coat. Remove the receiver collar from your pet and cut off the excess. If your receiver has a nylon strap, seal the edge of the cut collar by applying a flame along the frayed edge.

If your collar is a QuickFit collar, it is designed so you can quickly attach and remove the Receiver Collar from your pet while maintaining the desired fit.

  1. With the Snap Buckle fastened, thread the collar through the Metal Buckle.

  2. Slide the excess collar through the “C” Loop on top of the Snap Buckle. This will hold the excess collar in place.

  3. Once the collar fit is determined, use the Snap Buckle to remove and replace the collar.

Replacing the Receiver on a New Collar Strap

  1. Slide the receiver off the old strap.

  2. Slide the receiver on the new strap.

  3. Adjust the slide buckle so the collar won't become loose around your pet’s neck.

  4. Make sure the ridges are facing up or the collar may slip.


1-Year Limited Warranty.

Customer Reviews

37 Reviews 37 Reviews 4.5 out of 5 Stars

95% Recommend

95% of reviewersrecommend this product

4.5 / 5

You've Already Reviewed This Item

37 Reviews

Showing 1-10 of 37 Reviews

  • 5 out of 5 stars

    Worked great!

    By on

    It is great for us! We have a 6 month old lab and a big yard. We dug in 1000 feet of wire perimeter, so he has lots of room! Win/win!

    You liked it! Something went wrong. Please try again later. Report
  • 4 out of 5 stars

    Good product

    By on

    Had to return to manufacturer !These are good products but over the years ,I've got a couple bad ones . Manufacturer is prompt on replacements .

    You liked it! Something went wrong. Please try again later. Report
  • 5 out of 5 stars

    Goid product

    By on

    Exactly what I expected and exactly what I got. I think I got it within 24 hours. Super fast!!

    You liked it! Something went wrong. Please try again later. Report
  • 5 out of 5 stars


    By on

    We ordered this collar for our 11 year old in ground invisible fence. The collar was delivered within a matter of days and works great. Not only that, but it was less than half the price of the same collar on several different web sites. We thank you and our dog thanks you. Great job chewy.com! We'd order dog food, as well, but our dog is a small breed and the bags are too large and would go stale, we think.

    You liked it! Something went wrong. Please try again later. Report
  • 2 out of 5 stars

    not the best collar, but decent price

    By on

    Just received the collar and I'm a bit disappointed that the sounds emitted are so quiet. The stubborn dog version (which this replaced) has a much louder beep and vibrate mode. Both of which are helpful when training the dog. With this model it's going to be tough to know when the dog is about to be corrected as you can barely hear the tone. PetSafe should make the vibrate and loud beep standard on all collars

    You liked it! Something went wrong. Please try again later. Report
  • 3 out of 5 stars

    Nice collar, very light correction

    By on

    I didn't realize this collar was such a light correction, and my pets don't respond to it. I called Chewy and got a return label and will order the stubborn dog model. I've used the stubborn dog model in the past and it has worked great for even the worst escape artists. It uses a large battery but it's not uncomfortable for smaller dogs (even my cat that goes out).

    You liked it! Something went wrong. Please try again later. Report
  • 1 out of 5 stars

    They do not work with my system

    By on

    They do not work with my system even though it says they will I can't seem to get them to

    You liked it! Something went wrong. Please try again later. Report
  • 4 out of 5 stars

    By golly, it works!

    By on Top 1000 Contributor

    My dog is a rescue. He was found dumped in a ditch trying to nurse off his dead momma. He was one of only 2 who survived. Then he was brought up north and kept in a cage in the basement for 6 months. When I got him, he wanted to make up for his past experiences by "seeing the world." This collar taught him he could not do that on his own.

    You liked it! Something went wrong. Please try again later. Report
  • 5 out of 5 stars

    Petsmart collar

    By on

    Great product, always feel safe with my pets out using it

    You liked it! Something went wrong. Please try again later. Report
  • 5 out of 5 stars

    Super fast service

    By on

    I ordered a replacement collar for one of my “escape artists” after I broke his original and needed one right away. I ordered on a Wednesday afternoon and by Thursday afternoon it was here. Wow!!! Thanks Chewy!

    You liked it! Something went wrong. Please try again later. Report