Pet Acoustics Pet Tunes Calming Music Cat Speaker

Charging the Unit

Pet Tunes comes with a minimal battery charge when purchased. To completely charge, gently connect the small end of the Charging Cord into the Line-In port, as not to damage the port. Connect the USB end to your device, computer or a USB wall adapter. The Indicator glows red while charging. When the red light turns off, your Pet Tunes is fully charged. A full charge normally takes two hours. Once disconnected from power, the unit will continuously play Pet Acoustics Music up to 8 hours. To play 24/7, connect to a USB wall adapter. If music skips, the unit needs to be charged again.

Pairing via Bluetooth

Press the Pause/Pair button in the center until you hear a tone, indicating Pet Tunes is now in pairing Mode. The blue light flashes quickly while pairing. Go to the Bluetooth settings on your device, select Pet Acoustics and follow your device instructions. If your device asks for a PIN, enter 0000. You will hear the same tone once paired.

For Best Results

• Place the Pet Tunes unit near the hearing environment of your pet, about 4 feet (122 cm) above the floor.

• Loop the lanyard strap onto Pet Tunes to hang the unit on a crate, cage or stall.

• Keep Pet Tunes off the ground where dust, water or food may come in contact.

• Clean unit with a soft cloth.

Pet Tunes comes pre-loaded with 90 minutes of original Pet Acoustics music before it repeats.

The lithium ion battery typically lasts up to 8 hours, wirelessly. You can also play and charge Pet Tunes 24/7 inserting the USB plug into a USB wall adaptor.

You can use a computer USB insert or a USB wall adaptor.

Each Pet Tunes comes with a slight charge but should be charged for 2 1/2 hours for a full battery to play wirelessly.

We advise putting your selected music on a new Micro SD card which you can exchange with the card already in the Micro SD slot at the topof the Pet Tunes unit. To remove, press the SD card in and it will pop out.

You can play any music through the Bluetooth® feature, or pop out the Micro SD card and add other music on a different Micro SD card.

You can connect your computer, tablet or phone to the Pet Tunes speaker. Enter Bluetooth® pairing mode by holding down the play button until you hear a chirp. Now your device is ready to scan for it. Press “Pet Acoustics” to pair.

Pet Tunes comes with a USB cord. You can charge the unit to play wirelessly up to 8 hours.

Yes the music is audible for humans and people find the music calming too!

Pet Tunes plays continuously up to 8 hours on a full battery charge. You do not have to press any buttons to have the music play continuously.

Pet Tunes volume can be set loud enough to fill a large environment. Is it normal for there to be a delay before the music starts?

There is a 2 - 3 second delay and then the music will play. There will be a blue light blinking when Pet Acoustics music is playing.

If for some reason you have charged the unit and there is no music playing but the Blue light is on, pop out the Micro SD card and put it back into the slot gently until it clicks in and is flush with the top of the unit. In transport the units get jogged and the SD card can get out of alignment. Popping the card out and putting it back in will start the music if this is the issue.