PetNF Wireless Charging 304 Stainless Steel Automatic Dog & Cat Water Dispenser, 135-oz

Reassembly Steps:

1. Soak filter in water for about 5 minutes.

Note: The base compartment is strictly prohibited from being soaked!

2. Clean the water dish, and water tank under rinsing water.

3. Put the filter box in place.

4. Add water to the tank.

5. Put the water tray in place.

6. Install the Base compartment.

Note: Make sure the slot in the fountain bucket is aligned with the slot in the base, if not smoothly aligned rotate the fountain bucket.

7. Insert the water pump cord into the USB connect at the side of base. The pump cord should be stuck into the groove of the water tray.

Attention! press and hold the set button on the side of the base for 5 seconds to turn on the pet fountain.

A1: Replace the filter and sponge every 2 to 3 weeks for optimal performance.

A2: No, it’s ultra-quiet with a noise level less than 30 db, so you won't hear any sound even indoors.

A3: Ensure the connection ports are dry to avoid short-circuit. Connect the charger to the 5V1A charging port and the water pump to its corresponding port.

A4: With a built-in 5000mAh large-capacity lithium battery, it can last up to 60 days without being plugged in.

A5: It automatically dispenses water when a cat approaches within 80-120 cm from the front at 220° and also dispenses water for 10 seconds every half an hour.

A6: Yes, it has a unique transparent window design, convenient for observing water volume and preventing tripping at night.