Reptile Kages 4x2x2 Premium PVC Reptile Enclosure, 110-gal

Things to have before starting assembly: Phillips screwdriver or power drill-Flat surface to build on. A friend to help Please note -PVC is soft! Use caution as you tighten the screws and do not over tighten them (they should be sunk until flush with the enclosure surface). All the stickers should be inside of the enclosure once you finish assembling. Assembly: Please note -PVC is soft! Use caution as you tighten the screws and do not over tighten them (they should be sunk until flush with the enclosure surface). All the stickers should be inside of the enclosure once you finish assembling.

1) Place the back on a flat surface with label facing up.

2) Using screws provided, connect the bottom to the back.

3) Attach the left side to the bottom.

4) Attach the right side to the bottom.

5) Attach the bottom door track board to the bottom..

6) Stand the enclosure on the bottom.

7) Insert screws into the back to secure it to the sides.

8) Lay the top sticker-up on a flat surface and install any light fixtures to the ceiling.

9) Take the top and set it on top of the back & sides while feeding the cords through the notches cut into back.

10) Insert screws into the top securing it to the back & sides.

11) Insert glass door piece E into back of bottom door track.

12) Insert glass door piece F into the front of bottom door track.

13) Slide the doors together into the middle of the enclosure.

14) Align doors into top door board tracks and insert screws through the top into the door board .

15) Slide the doors back and forth to make sure they’re correctly installed.

16) Insert screws into the sides securing the door track boards to the sides. 17) Attach the center brace into the inside middle of the enclosure. It attaches to the top & bottom door boards with the smaller, ¾” screws.

18) Clean the inside with a reptile safe cleaner and allow to dry & air out before placing your animal in the enclosure.

YES! We have several of our personal enclosures setup bio-active and LOVE it! Our enclosures do not require any special litter guards or plastic liners to be used bioactive. Kages enclosures all come bioactive ready!

Can I place loose substrate in the cage?

Absolutely! We have designed our reptile enclosures to allow for adequate substrate. 2 series enclosures have a 4" substrate board allowing room to place the perfect amount of substrate for your reptile.

Is the reptile enclosure sealed?

We use a non-porous PVC that’s moisture resistant. We recommend purchasing reptile safe silicone so you can seal the seams. Silicone is optional however we recommended it for use with bio-active setups and snakes. Moisture from general use and a bio-active setup will not cause issues with the enclosure. However it is not waterproof like an aquarium meaning it will not hold water.

Are the enclosures stackable?

Yes, however we urge you to use common sense. The enclosures weigh over 50 pounds empty, and we do not recommend stacking more than 250 pounds onto any enclosure.