Things to have before starting assembly: Phillips screwdriver or power drill-Flat surface to build on. A friend to help Please note -PVC is soft! Use caution as you tighten the screws and do not over tighten them (they should be sunk until flush with the enclosure surface). All the stickers should be inside of the enclosure once you finish assembling. Assembly: Please note -PVC is soft! Use caution as you tighten the screws and do not over tighten them (they should be sunk until flush with the enclosure surface). All the stickers should be inside of the enclosure once you finish assembling.
1) Place the back on a flat surface with label facing up.
2) Using screws provided, connect the bottom to the back.
3) Attach the left side to the bottom.
4) Attach the right side to the bottom.
5) Attach the bottom door track board to the bottom..
6) Stand the enclosure on the bottom.
7) Insert screws into the back to secure it to the sides.
8) Lay the top sticker-up on a flat surface and install any light fixtures to the ceiling.
9) Take the top and set it on top of the back & sides while feeding the cords through the notches cut into back.
10) Insert screws into the top securing it to the back & sides.
11) Insert glass door piece E into back of bottom door track.
12) Insert glass door piece F into the front of bottom door track.
13) Slide the doors together into the middle of the enclosure.
14) Align doors into top door board tracks and insert screws through the top into the door board .
15) Slide the doors back and forth to make sure they’re correctly installed.
16) Insert screws into the sides securing the door track boards to the sides.
17) Attach the center brace into the inside middle of the enclosure. It attaches to the top & bottom door boards with the smaller, ¾” screws.
18) Clean the inside with a reptile safe cleaner and allow to dry & air out before placing your animal in the enclosure.
