PawBrands PupProtector Memory Foam Dog Car Bed, Grey, Single Seat

Outer Cover: Make sure to remove memory foam and bolster cushions from the bed cover. Close the zippers of the outer cover. Wash the outer cover with cold water on the gentle cycle. Tumble dry with low heat. Memory Foam Liner: Remove memory foam from the liner. Close the zippers of the liner. Wash the memory foam liner with cold water on the gentle cycle. Tumble dry with low heat.

First flip the cover inside out so the inner zipper is visible. You will know this is correct as the rubber non-slip bumps will no longer be visible on the bottom. Now open the inner zipper all the way around (opens on three sides of the bed). This will expose three open compartments for our bolsters. Place the side bolsters in the two side compartments. These will be the two matching bolsters which have two rounded sides. Place the front bolster in the front compartment. Be sure to leave the flat side of this bolster facing what is currently the exterior of the bed. Now close the interior zipper and flip the bed right side out again. You will know this is correct as the rubber non-slip bumps will be at the bottom of the bed. And the leash attachment will now be visible inside of the bed. Next take the memory foam base and insert it into the memory foam base cover. Take the memory foam base and insert it into the bed, adjusting it so it fits snug beneath the bolsters. You will need to make sure the leash attachment remains above it for easy access when securing your pet for travel. The bed is now ready for installation in your vehicle.